Triax EoC EP Ethernet PoE/WiFi

Ethernet WiFi Endpoint, with dual-band, used with the Triax Ethernet over Coax Controller

5 GHz Wi-Fi - 802.11ac MU-MIMO
2x Ethernet port
PoE input: PoE-in 802.3af / PoE+in 802.3at
PoE output: PoE-out 802.3af
VLAN support
Layer 2 Isolation
Power supply requirements:
PoE (802.3af) 15.4W when NO PoE powered device on PoE output (Ethernet 2)
PoE+ (802.3at) 30W when PoE-powered device on PoE output (Ethernet 2)

SKU :-383230

Trade log in

£0.00

£258.78

The EoC Ethernet WiFi Endpoint, with dual-band concurrent Wi-Fi, is used with the Triax Ethernet over Coax Controller (EoC) and is intended to provide Wi-Fi access in rooms without Coax cables. This is often the case for conference rooms, corridors, lobbies, bars, etc.

The PoE Access Point is powered via Ethernet (PoE) to make the installation easy and independent of a power outlet. This will require the installation of an ePoE+-compliant Ethernet switch connected to the EoC Controller.

The PoE Access Point also has a PoE output (passthrough) to supply power to other PoE devices. This could be a 2nd PoE Access Point, an IP phone, a Camera or other devices in the same room.

If the PoE output is not used, the AP can be switched to power save mode to accept a reduced PoE input power.

Spec Sheet